Install and first launch
PicLatch is built for iPhone. There’s no account to make: no sign-up, no email address, no password. You open the app and start.
PicLatch is not on the App Store yet. When it is, you’ll install it like any other app. To hear when that happens, join the waitlist.
You don’t need a signal to take photos. See Capturing without signal for what changes offline.
Open it for the first time
Section titled “Open it for the first time”The first screen has three controls.
- Skip takes you to Home. You can still seal your first photo from there.
- How sealing works opens a short explainer. It’s the only explainer before you start.
- Start my Move-In Record shows a short note that your camera seals each photo as it’s taken, with an Open the camera button.
Camera access
Section titled “Camera access”PicLatch seals each photo right after you take it, so it needs your camera. On a new install, Open the camera takes you to a screen called Camera Access Needed. That’s expected the first time, and it isn’t an error. It also has a Skip for now button during first launch.
Tap Grant Camera Access. iOS then asks for permission and shows PicLatch’s reason: “PicLatch uses the camera to take and seal photos of your apartment’s condition.” Allow it. A photo shows one moment from one angle, so read What sealing does NOT prove for the limits.
If you said no before, the Camera tab shows the same screen again. See Camera and location permissions.
Location, if you want it
Section titled “Location, if you want it”Location puts a place on your photos. It’s optional, and PicLatch never asks for it automatically. There are two ways to turn it on.
- The Add where to your proof card, with its Add location button. It’s on the screen where you choose Essential pass or Complete record, and it appears during first-run setup if location isn’t already on.
- Add, next to the location line on the Camera screen. This is the later way, and the only in-app way if you tapped Skip.
PicLatch asks iOS for location only while you’re using the app. iOS shows PicLatch’s wording: “PicLatch adds your location to each photo it seals, so the photo records where it was taken. Location is optional.”
A recorded location can still be wrong, as What sealing does NOT prove explains. Photos are still sealed without it, just without a place.
The first photo is usually sealed before you’ve been asked. So you’ll likely see Location: not added yet — you can add it next on your first Sealed card. That’s expected.
Ready for your first photo?
Section titled “Ready for your first photo?”Head to Your first Move-In Record. It walks you through the front-door shot and the rest of your home.
New to what a seal does and doesn’t show? Read What PicLatch does and doesn’t do.
Still stuck? Email us at support@piclatch.com.