Skip to content

Camera and location permissions

Two iOS permissions matter when you take photos in PicLatch: camera and location. The camera is needed. Location is optional. iOS has the final say on both, and the Settings steps below are iOS instructions. Menu names can vary a little between iOS versions.

PicLatch seals each photo right after you take it, so it needs the camera. If access is off, the Camera tab shows Camera Access Needed: “PicLatch needs camera access to add condition photos to your Move-In Record.” Tap Grant Camera Access to bring up the iOS prompt. During your first launch you’ll also see Skip for now.

If camera access is refused, PicLatch shows an alert titled Camera Access Needed that reads “Please enable camera access in Settings to take move-in photos.” Tap OK. iOS may not show its prompt a second time, and the app has no button that opens Settings, so open it yourself:

  1. Open the iPhone’s Settings app.
  2. On iOS 18 and later, scroll down, tap Apps, then tap PicLatch. On iOS 17 and earlier, scroll down and tap PicLatch instead.
  3. Turn on Camera.
  4. Go back to PicLatch. If the screen doesn’t update, close the app fully and open it again.

Location is optional, and photos are still sealed without it. PicLatch only asks while you’re using the app. These are the status lines on the Camera screen.

  • Location off. You turned it off. Tap On next to the line to turn it back on.
  • Getting location… PicLatch is asking your phone where you are.
  • Location will be included. PicLatch has a location to use for your next photo.
  • Location blocked. iOS access was refused. Retry asks again.
  • No location yet. PicLatch doesn’t have one. If you haven’t been asked yet, an Add link appears beside it.

Retry asks iOS again, but once you’ve refused, iOS may not show the prompt a second time. If nothing happens, change it in Settings:

  1. Open Settings. On iOS 18 and later, scroll down, tap Apps, then tap PicLatch. On iOS 17 and earlier, scroll down and tap PicLatch instead.
  2. Tap Location and choose While Using the App.
  3. If you see a Precise Location switch, turn it on. With it off, iOS may give PicLatch only an approximate location.
  4. Go back to PicLatch. If it still says Location blocked, tap Retry, or close PicLatch fully and open it again.

If Location Services is off for the whole phone, PicLatch can’t get a location either. You’ll find that switch in Settings under Privacy & Security.

Photos sealed without a location stay that way. You can’t add one afterwards, because the location is sealed with the photo.

Still stuck? Close PicLatch fully, reopen it, and email us what you see. Our address is at the bottom of this page.

For how a recorded location can be wrong, read What sealing does NOT prove. To see what else goes into a photo, read What a Sealed Photo contains.

Still stuck? Email us at support@piclatch.com.